DSC WTK5504 Manuel d'installation télécharger pdf (Page 11)

If the zone is disarmed and the tamper (open) or fault

(short) condition is tripped a buzzer will sound from all

partition keypads for the length of Bell Time Out or until an

access code is entered. A zone tamper will be sent to the

monitoring station if programmed. See Reporting Codes

for details.

If the zone is armed and the tamper is activated, it will

transmit and log both the tamper alarm and the zone

alarm. There will be no buzzer sounded if the zone is

armed (unless the zone is programmed as a 24 hour

buzzer zone). See the “Control Panel Wiring Diagram” for

detail on the hookup procedure.

The type of circuit or zone definition (delay, instant, 24

hour, silent, audible, etc.) is programmed from the keypad

using the installers programming commands.

Telephone Terminals

“TIP”, “RNG”, “T-1” and “R-1”

The wires from the RJ31-X telephone jack are connected

to these terminals in the following way.

NOTE: For proper operation, there must be no other

telephone equipment connected between the

control panel and the telephone company’s

facilities.

Ensure that plugs and jacks meet the dimension,

tolerance and metallic plating requirements of 47

C.F.R. Part 68 Subpart F.

TIP Green wire

Incoming line from

RNG Red wire

telephone company

T-1 Brown wire

Outgoing line to

R-1 Grey wire

house telephone(s)

Battery Connections

Do not connect the battery or the transformer until the

wiring is complete. Connect the red battery lead to the

positive battery terminal and the black lead to the

negative battery terminal. If the connection is reversed the

battery PTC will blow.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Pas de commentaire

DSC WTK5504 Manuel d'installation Page 11