DSC WLS920 Manuel d'installation télécharger pdf (Page 9)

i n s t a l l a t i o n s t e p s

3.4 Module Placement Test

You must test the placement of each wireless device before you permanently mount them. The module

placement test will determine whether the location you have selected is Good, Fair or Bad. If you get a Bad

result, relocate the device and perform the test again. To test each wireless device, perform the following:

1. Enter Installer’s Programming and enter programming section [904].

2. Enter the two digit zone number for the device to be tested

3. Test each device according to their type:

Door Contact. Open and close the contact by moving the magnet or by operating the external device

connected to the contact. The control unit will display the test result after the zone is restored.

Motion Detectors and Smoke Detectors. Remove the Detector from its backplate, wait for 5 seconds,

then reattach the Detector to its backplate. The control unit will display the test result after the Detector is

reattached to its backplate.

4. Verify the results of the test using the following table:

Good ...............Light 1 On Steady ...........1 Beep

Fair ..................Light 2 On Steady........... 2 Beeps

Bad..................Light 3 On Steady...........3 Beeps

5. Continue Steps 3 through 5 until each device has been tested.

Wireless devices can be mounted where results were Good or Fair. No device should be mounted

where a Bad test result was indicated. If multiple tests on the same device are performed you

must wait at least 10 seconds between tests.

WLS908 Panic Pendant Test

The panic pendant cannot be tested in the module placement test, so follow these steps:

1. Begin testing when your system is in the ready state and the Ready light is ON.

2. Press and hold the small middle button on the pendant marked “Test” for two seconds. Once the test is

complete and if the pendant’s battery condition is normal, the Ready light will turn off for four to five

seconds.

3. If the pendant’s battery is low, the Trouble light will turn ON and a series of continuous beeps will be heard.

This test should also be performed by the user when they perform a weekly system test.

If a low battery condition is detected, you must immediately replace the unit. Once you have obtained the new

unit, perform the following:

1. Enter Installer’s Programming and enter programming section [804].

3. Enter the two digit number for the pendant to be replaced.

4. Enter serial number [00000].

5. Enter the two digit number for the pendant being replaced.

6. Enter the serial number of the new pendant. Press [#] twice to exit Installer Programming.

3.5 Supervision

Wireless zones are supervised so that a trouble is generated when a device ceases to operate or is removed

from the system. To enable zone supervision, enter the following:

1. Enter Installer’s Programming and enter programming section [804].

2. Enter section [82] to enable or disable wireless zone supervision (see Section 2.4 “Programming Toggle

(ON/OFF) Option Sections” for how to program these options).

The supervisory option for any WLS908 panic pendants enrolled on the system must be OFF.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

DSC WLS920 Manuel d'installation Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité DSC WLS920