DSC Envoy NT9010 Guide d'installation télécharger pdf (Page 26)

Programming Worksheets

24 ••Refer to section xx and page xx in the Installation Guide.

[093] RF Jamming Detection Zone (2.3.6 “RF Jamming Detection Zone” on page 40••)

NOTE: Programming RF Jam Zone will automatically program the corresponding label as RF Jam.

Please be sure that the corresponding serial number is (000000). RF Jam will not work properly other-

wise.

NOTE: Zone supervision must be disabled for RF Jam Detect zones and hardwired zones.

Programming the System and Zone Labels (2.1.5 “Programming Audio Labels” on page 16••)

You can program labels for the system and for the zones through the NT9010 Flash Programming, or through the

following programming sections. To program the labels using these programming sections:

1. Enter the 3-digit sub-section for the label ([601] to [633]).

2. Enter the 3-digit code for each word you want to program. You can enter up to six words for each label.

Please see “Audio Label Library” on page 27 for a list of the 3-digit codes for each available word. To add

numbers to a label, see 2.1.5 “Programming Audio Labels” on page 16. If your label is less than six words,

press [#] at the end of the label.

3. If you want to use a recorded label, in place of the first word of the label, enter [244] then the number of the

label [001] to [005]. The recorded label will replace all six words in the section. To record a label, see 2.1.5

“Programming Audio Labels” on page 16••.

4. When you have entered the label, the system will recite it.

5. If the label is correct, press [#]. To change the label, repeat steps 1-4, above.

Default

I_______I_______I

Select an unused zone that will go open when a jamming signal is present.

Valid entries 01-32, 00 = disabled

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

DSC Envoy NT9010 Guide d'installation Page 26