DSC PC1404 v1.1 Manuel d'utilisateur télécharger pdf (Page 18)

Setting the System Date and Time

To set the system time, enter [][6] followed by the Master Code. Press [1]. The keypad will now

accept 10 consecutive digits:

•Enter the Time in Hours and Minutes using the 24 Hour format (00:00 to 23:59).

•Enter the Date in Months, Days and Years (MM DD YY).

NOTE: If you have an LCD keypad, your installer may have programmed your system to

display the time and date while the keypad is idle. If this is the case, you may have to press

the [#] key to clear the date and time to show system status before entering an access

code to arm the system, or before performing any other keypad function.

Door Chime Feature

The door chime feature is used to provide a tone from the keypad each time a door or window is

opened or closed. The doors and windows which will provide this indication are programmed by

your installer.

To activate the door chime from an LED Keypad:

Enter [ ][4] to turn the door chime feature ON and OFF. When the command is entered, the keypad

buzzer will beep 3 times if the door chime feature is enabled and will sound one long beep if it is

disabled.

To activate the door chime from an LCD Keypad:

Downloading Enable

To enable a six-hour downloading window from any system keypad, enter [] [6] [Master Code] [5].

During this time, the panel will answer incoming downloading calls. For more information, please

ask your installer.

Fire Alarm Operation

Alarm

On a fire alarm, the bell or siren will activate following the programmed cadence.

Silence

To silence the bell or siren, press the [#] key. If the alarm is silenced and the smoke detector is not

reset, the alarm will re-sound after 90 seconds.

Resetting Smoke Detectors

Once the smoke detector is reset, if it still detects smoke, the alarm sequence will re-sound as

described above. If there is no smoke, the system will return to normal.

To reset smoke detectors from an LED Keypad:

Press [][7][2].

To reset smoke detectors from an LCD Keypad:

Press [] to enter the function list, then scroll to find

Press [] or [4] to enable or disable the Door Chime feature. Press

[#] to return to the Ready state.

Press [] to enter the function list, then scroll to find

Press [] to select the output control. The display will read

Press <*> for <>

Door Chime

Press <*> for <>

Output Control

Scroll to

Select Output <>

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

DSC PC1404 v1.1 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité DSC PC1404 v1.1