DSC PowerSeries PC1864 Guide d'installation télécharger pdf (Page 60)

PowerSeries - PC1616/PC1832/PC1864

Trouble Cause Troubleshooting

Trouble [5] Zone Fault (Cont.)

One or more wireless devices have not

checked in within the programmed time

• If the trouble occurs immediately, a conflict with a hard wired

zone exists:

• The zone being used is already assigned to a PC5108 zone

expander

• The zone being used is assigned as a keypad zone

• Perform a Module Placement Test – Program Section [904] and

verify the wireless device is in a good location.

• If bad test results occur, test the wireless device in another

location

• If the wireless device now tests good, the original mounting

location is bad

• If the wireless device continues to give bad test results

replace the wireless device

A short circuit is present on one or more

zones with double end-of-line resistors

enabled

• Remove the wire leads from Z and COM terminals and measure

the resistance of the wire leads.

• A short circuit indicates a short in the wiring.

• Connect a 5.6K resistor (Green, Blue, Red) across the Z and

COM terminals.

• Verify the trouble condition clears.

Trouble [6] Zone Tamper Press [6] to determine specific zones with a tamper trouble

A tamper condition is present on one or

more wireless devices

• Perform a Module Placement Test –Section [904]

• Violate, then restore the tamper:

• If no test result then replace wireless device

An open circuit is present on one or more

zones with double end-of-line resistors

enabled

• Remove the wire leads from Z and COM terminals.

• Measure the resistance of the wire leads.

• Open circuit indicates a break in the wiring.

• Connect a 5.6K resistor (Green, Blue, Red) across the Z and

COM terminals.

• Verify the trouble condition clears.

Trouble [7] Wireless Device Low Battery Press [7] to toggle through specific devices with low battery trouble

1st press

– Wireless Zones

2nd press

– Handheld Keypads

3rd press

– Wireless Keys

One or more wireless devices has a low

battery

NOTE: The event will not be logged to

the event buffer until the wireless device

low battery delay time expires

• Program Section [377] Opt 9

Replace battery

NOTE: Replacing batteries will cause a tamper. Replacing cover will

restore the tamper causing the associated reporting codes to be sent

to the Central Station.

Trouble [8] Loss of Clock/Date

The main panel internal clock is not set To program the time and date:

• Enter [✱][6][Master Code] then Press [1]

• Enter the time and date (in military) using the following format:

HH:MM MM/DD/YY

Example.

For 6:00 pm, June 29, 2005

Enter: [18] [00] [06] [29] [05]

IMPORTANT!

Ensure you have the following information available before contacting Customer Support

- Control Panel Type and Version, (e.g., PC1864 v4.1)

NOTE: Version number can be accessed by entering [

✱][Installer Code][900] on any LCD keypad. This informa-

tion is also located on a sticker on the Printed Circuit Board.

- List of modules connected to Control Panel, (e.g., PC5400, PC5204 etc.)

1 2 ... 55 56 57 58 59 60 61 62 63 64

Commentaires sur ces manuels

Pas de commentaire

DSC PowerSeries PC1864 Guide d'installation Page 60

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité DSC PowerSeries PC1864