DSC Power432 PC585 Manuel d'installation télécharger pdf (Page 11)

Getting Started: 2.11 Keypad Zones

Assigning Keypad Zones

When using keypad zone inputs, each input used must be

assigned a zone number in Installer’s Programming.

First, ensure that you have enrolled all installed keypads into

the desired slots. (see 2.5 “Keypad Assignment” )

Next, enter programming section [020] to assign the zones.

There are eight programming locations in this section, one for

each keypad slot. Enter a 2-digit zone number for each of the

keypad zones. This number must be entered in the location

corresponding to the keypad to which each zone is con-

nected.

Example: The zone on an LCD5500Z keypad in slot 8 is to be

assigned zone 3. In section [020], scroll to option [8] and

enter (03).

NOTE: Keypad zones 1-4 will replace zone terminals Z1-Z4

on the control panel.

NOTE: Once the keypad zones are assigned, you must also

program zone definitions and zone attributes. (See also 5.4

“Assigning Keypad Zones”).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Pas de commentaire

DSC Power432 PC585 Manuel d'installation Page 11