DSC WLS900 Instructions d'exploitation télécharger pdf (Page 12)

3 F: Reviewing the List of Enrolled Components

In the Installer’s Programming Mode, you can display a list of all the components enrolled on

the system. This function will display all of the detection devices and the zones they are

assigned to, as well as the number of Sounders and Keypads enrolled on the system.

Chapter 3: Adding Components

Entering the Enrollment Mode

(See Section 3B to Enter the Enrollment Mode)

Press the -YES Key when this message

is displayed.

Use the -NO Key to scroll to this

message. Press the

-YES Key when this

message is displayed.

Use the

-YES Key to scroll through the

list of system components.

Detection Devices will be indicated with

messages similar to this one.

Sounders will be indicated with messages

similar to this one.

Keypads will be indicated with messages

similar to this one.

When all components have been displayed,

this message will be displayed.

To display the Serial Number of a

component, press the [

∗

] Key while

reviewing Enrolled Components List. When

the [

∗

] Key is pressed, a message similar to

the one shown here will be displayed for a

few seconds.

The "ZONE LABEL" can be any discription of up to 16 letters, numbers, spaces or ASCII

characters. See Section 6 for more information.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Pas de commentaire

DSC WLS900 Instructions d'exploitation Page 12