DSC PC6010 Manuel d'utilisateur télécharger pdf (Page 19)

6.3 “Warning - Security Reduced”

Messages

These messages are displayed on the keypad if a user tries to

arm the system when there is a problem with one or more zones

(i.e. a zone is open, in alarm, or has a fault, tamper, seismic fault

or trouble condition).

The following message will be displayed on the keypad:

“Warning - Security Reduced”

If this message is displayed, users can continue arming their

area(s) by pressing the YES button. The keypad then displays

“Warning Confirmed”, and the area(s) are armed.

6.4 Time and Date Display

When the keypad is idle, it will show the time and date. The

clock will show in 24-hour time (00:00 - 23:59), and the date

will show as year/month/day (YY/MM/DD). For example, 1:30 pm

December 13, 1999 will be displayed as 13:30 1999/12/13

The system will automatically adjust for the switch to daylight

savings time in March, and back to standard time in October.

The dates that these changes occur on are programmed in the

Daylight Savings and Standard Time programming sections. See

System Times in the PC6010 Programming Manual for more

information.

If the system is connected to Alarm Presentation Software over

the backbone, the system will get the new time from the

software, and will not follow the Daylight Savings Time /

Standard Time programming sections.

Master users also can reset the time and date through the user

interface. See the Maintenance Manual for more information.

6.5 Keypad Lockout

After a programmed number of incorrect attempts to enter a user

or installer code, the keypad will lock out the user. The lockout

prevents the user from performing any function at any keypad.

The keypad will display “Keypad Lockout is Active” for the

lockout duration. See the “System Options” section in the

Programming Manual for information on programming the

number of incorrect code entries allowed (Total Bad Codes), and

how long the keypad will remain locked out (Lockout Duration).

6.6 Keypad Tampers

If there are tamper plates attached to the PC6501 keypad, you

should enable the Keypad Tampers toggle option. See the

“System Options” section in the Programming Manual.

6.7 Keypad Backlighting

When a user presses a key on the keypad, the keypad

backlighting will increase to the “boost” level. After 30 seconds

of inactivity, the keypad will return to the preset backlight level.

Master and Supervisor users can select the level of (non-boosted)

backlighting in the Keypad Setup section of the user menu.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

DSC PC6010 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité DSC PC6010