DSC PC5020 Manuel d'installation télécharger pdf (Page 5)

PC5020 Wiring Diagram

NOTE: AUX+ (420mA) is

shared between AUX+,

Keybus and all PGM outputs

WARNING:

Not to be removed

by anyone except occupant.

This equipment should be

installed in accordance with the

National Fire Code ANSI/NFPA

72 (National Fire Protection

Association, Batterymarch Park,

Quincy MA, 02269). Printed

information describing proper

installation, operation, testing,

maintenance, evacuation

planning, and repair service is

to be provided with this

equipment. For compliance with

UL-985, at least one hardwired

smoke detector is required.

(a) The delay (power-up) (start-up) time marked on the

installation wiring diagram of the smoke detector or on the

installed smoke detector(s) is to be used.

All circuits are classified for UL installations as power limited / Class2

power limited, except for the battery leads. Do not route any wiring over

circuit boards. Please see Installation Manual Section 2.3, Installation &

Wiring. A minimum 1/4” (7mm) separation must be maintained at all points

between power limited wiring and all other non power limited wiring.

WARNING

High voltage. Disconnect

AC power and telephone

lines prior to servicing.

APPLICABLE UL STANDARDS

UL FILE NO. S4019

UL1610 Central-Station Burglar-Alarm Units

UL609 Local Burglar Alarm Units and Systems

UL365 Police Station Connected Burglar Alarm

Units & Systems

UL985 Household Fire Warning System Units

UL1023 Household Burglar-Alarm System Units

UL1635 Digital Alarm Communicator System Units

UL1637 Home HealthCare Signaling Equipment

PC5020 Wiring Diagram

WWW.DIYALARMFORUM.COM

1 2 3 4 5 6 7 8 9 10 ... 52 53

Commentaires sur ces manuels

Pas de commentaire

DSC PC5020 Manuel d'installation Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité DSC PC5020